Maverick Remote ET-73 Smoker Thermometer

The Maverick Remote ET-73 Smoker Thermometer by Maverick Industries is our most popular smoker thermometer. The Maverick ET-73 Remote Smoker Thermometer monitors both meat and smoking chamber temperatures! Check the meat and smoking chamber temperatures from up to 100 ft. away.

• If the receiver and / or transmitter display LLL or HHH instead of the probe temperature, wait for probe to reach room temperature. If LLL or HHH is still displayed it is likely the internal probe wire has shorted out either through moisture or heat damage.
• Do not immerse the probe in water while cleaning.
• Do not allow the probe or probe wire to come into contact with flames.
• If the temperature displayed seems to read too high or the temperature seems to increase too quickly check to make sure the probe tip is not poking through the food to outside. Reposition the probe tip in the center of the thickest part of food. Avoid touching bone or heavy fat areas.

• Always wear a heat resistant glove to touch the stainless steel probe sensors or wires during or just after cooking. Do not touch with bare hands.
• Keep the stainless steel probe sensors and wires away from children.
• Clean the stainless steel probes and dry thoroughly after each and every use.
• Do not use the receiver in the rain. The transmitter is water proof but not water tight. Don not immerse in water.
• Do not expose the plugs of the stainless steel probes or the plug in holes of the transmitter to water or any liquid. This will result in a bad connection and faulty readings.
• Do not expose the receiver or transmitter to direct heat or surface.
• Do not use stainless steel probes in microwave oven.
• Register temperatures as low as 14º F (-10º C) and as high as 410º F (210º C). LLL will be displayed below 14º F and HHH will be displayed above 410º F. Do not use the stainless steel probe sensor above 410º F. Doing so will deteriorate the wire.
• Not intended for use by persons ages 12 and under.

• Always wear a heat resistant glove to touch the stainless steel probe sensors or wires during or just after cooking. Do not touch with bare hands.
• Keep the stainless steel probe sensors and wires away from children.
• Wash the metal probe tips with hot soapy water and dry thoroughly. Do not immerse the probes in water while cleaning.
• Wipe the transmitter and receiver with damp cloth. Do not immerse either in water.