The Natural Alternative to Chlorine
(and Bromine too!)

• Lasts four months
• Makes spas easy to manage, halogen-free
• Improves performance of ozone-equipped spas
• Assures an odor-free spa
• Significantly improves look & feel of water
• Simplifies water balance it's unaffected by heat
• 9 out of 10 spa users prefer Nature2 over their old method

Specifications:
Capacity: for spas up to 1,000 gallons
Run time: minimum 4 hours daily
Flow rate: works with all spa flow rates
Installation: Drops into the core of most spa filters, works with suction-side and pressure-side filters

Installation:
CAUTION: Consult your spa owner's manual before opening your filter.

Step 1
Connect the support stems together and press onto main body to create a single device. (Refer to Image #2)

Step 2
Slide the entire device into the core of your existing spa filter cartridge. (Refer to Image #3)

Open Top
Simply slide unit in from the top. Position near the top half of the cartridge. (Support stems may be cut to position the cartridge correctly.)

Open Top with Stand Pipe
Some spa filter systems are configured with a standpipe running the length of the filter core. Simply slide unit in from the top. Position near the top half of the cartridge for easy retrieval.

Closed Top
Simply slide unit in from the bottom. Position unit to rest on shelf inside filter core.

Note: When installed, the Spa Purifier must be at least 1" (2.5 cm) above the bottom of the filter to prevent blocking water flow.

The Company assumes no liabilities for the product if installed in any way other than the methods described above.